Using The Cooling Unit; Energy Saving Tips - Dometic ColdMachine 50 Instructions De Montage Et De Service

Coldmachine
Connecting to a 230 V mains supply
!
WARNING!
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooling device on board a boat with
a mains connection of 230 V from the land, you must install a residual
current circuit breaker between the 230 V mains supply and the
cooling device.
Seek advice from a trained technician.
➤ To operate the cooling unit from the 230 V mains, use the rectifier
– CoolPower EPS100 for devices with BD35F compressor
(50/80/CS/CS series),
– CoolPower MPS35 for devices with BD35F compressor
(50/80/CS/CS series),
– CoolPower MPS50 for devices with BD50F compressor (90 series).
I
NOTE
The output voltage of the described rectifier is 24 V. Please remember
this when connecting other consumers at a later time.
8

Using the cooling unit

8.1

Energy saving tips

• Choose a well ventilated installation location which is protected from direct
sunlight.
• Allow hot food to cool down first before placing it in the device.
• Do not open the refrigerated container more often than necessary.
• Do not leave the door open for longer than necessary.
• Defrost the refrigerated container once a layer of ice forms.
• Avoid unnecessary low temperatures.
• Clean the condenser of dust and dirt at regular intervals.
• Clean the lid seal regularly.
EN
Using the cooling unit
25