Battery Replacement And Charging - cecotec CONGA 4090 Manuel D'instructions

ENGLISH

8. BATTERY REPLACEMENT AND CHARGING

• Do not use any other battery, power adapter or charging base than the one provided
officially by Cecotec.
• Do not use non-rechargeable batteries.
• Do not remove, dismantle or attempt to repair the battery or the charging base.
• Do not place the charging base near heat sources.
• Do not use a wet cloth to wipe any of the parts of this product.
• It is suggested to charge the battery every month in order to avoid damage to the battery.
• Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
9. TROUBLESHOOTING
Problem
The robot does not start up
or does not clean
The robot cannot charge or
return to the charging base
The robot does not work
properly
The robot emits a strange
noise during cleaning
The robot does not clean
efficiently or dust leaks
from the robot.
42
Solution
• The robot cannot operate when the battery is low. Allow it
to charge before operating it.
• The room temperature is below 0 ºC or above 50 ºC.
Operate the robot in a room where the temperature is
between the stated temperature range.
• There are too many obstacles near the charging base,
relocate the charging base to an area free of obstacles.
• Clean the charging terminals.
• Make sure the power switch is turned on.
• The robot is too far away from the charging base, place it
closer and try again.
• There is very little free space around the charging base.
• Make sure the charging terminals are clean.
• Turn the robot off, switch it off and turn it on again.
• The main brush, side brush or omnidirectional wheel may
have foreign matters tangled, stop the robot and clear it up.
• The dust tank is full. Empty it and clear the high-efficiency
filter if it is blocked.
• The high-efficiency filter is blocked, clear it.
• The main brush is tangled with foreign matter, please clear
it up.