cecotec CONGA 4090 Manuel D'instructions page 41

ENGLISH
SILICONE BRUSH
To clean the silicone brush, follow the instructions on the
previous section to remove it from the robot and wash it with
water and soap. Dry it thoroughly before installing it back to
ensure it operates efficiently.
CEPILLO JALISCO (BRUSH)
To clean the Jalisco brush, follow the previous section's steps
to take it out and clean it with water. Dry it thoroughly before
installing it back to ensure it operates efficiently.
DUST TANK
1. Out the dust tank. Take.
2. Open dust tank and empty it.
3. Use the cleaning brush to clean the inside of the dust tank.
4. Install the dust tank back in the robot.
WET & DRY TANK
1. Take out the Wet & dry tank.
2. Separate the dust compartment from the rest of the tank.
3. Open dust compartment and empty it.
4. Use the cleaning brush to clean the dust compartment.
5. Assemble the dust compartment in the Wet & dry tank.
6. Install the Wet & dry tank back in the robot.
7. If the Scrubbing mode has been used, empty the water inside the tank and then fill it with
clean water to rinse it. Empty it again before installing it back in the robot.
40
1 2 4