Christopeit Sport CPS 2 Notice De Montage Et D'utilisation page 15

Step 4:
Installation of the saddle support (49) on the main frame (1) with the
saddle support screw (47).
1. Push the saddle support wrapping (43) onto the saddle support (49).
Insert the saddle support (49) into the provided holder of the main
frame (1) and secure at the desired position by screwing in the saddle
support screw (47).
(Note: To screw in the saddle support screw (47), the threaded hole in
the main frame (1) and one of the holes in the saddle support (49)
must be aligned. Furthermore, ensure that the saddle support (49) is
not pulled out of the main frame beyond the marked maximum
adjustment position. The setting of the saddle support can be adjusted
as desired later.)
Step 5:
Connecting the computer cable harness incl. sensor (45) to the
computer cable harness (54), connection of the cable of the resistance
adjuster (38) with the resistance adjusting unit (36) and installation of
the handlebar support (25) on the main frame (1) with the round-headed
Allen screws M8x15 (55), washers 8//20 (19) and spring washers for M8
(72).
1. Place the lower end of the handlebar support (25) against the main
frame (1). Plug the ends of the two computer cable harnesses (45) and
(54) projecting from (1) and (25) together.
2. When the cable connections have been made, push the cable (38) from
the bottom through the handlebar support (25) and pull out of the opening
at the upper end of the tube. Then push the handlebar support (25)
onto the main frame (1).
(Note: When joining the tubes, ensure that the harness and cable
connections are not trapped.
3. Put one spring washer and one washer on each screw. Push the screws
through the holes in the support, screw into the threaded holes of the
main frame (1) and tighten firmly.
4. Join the two ends of the cables (36) and (38) as indicated in the drawing
below (A+B).
(Note: Before this step of the installation, it is advisable to adjust the
resistance setting to the highest stage, at which the cable extends
furthest from the sheath.
If the factory adjusted pedal resistance range of the machine should
later be found to be too great or too small, this can be simply adjusted
as the cables. For this, loosen nut of cable (38), turn the threaded piece
correspondingly and secure the new position with nut. In this respect:
The further is screwed into the U-piece, the greater the resistance, and
the converse.)
When the connection has been made, insert the resistance adjusting
unit (36) into the opening of the handlebar support (25) and secure with
screw (35).
Step 6:
Installation of the handlebar (40) on the handlebar support (25) with
the carriage bolt M8x90 (57), the spring washer for M8 (72), the was-
her 8//20 (19) and the handgrip nut (62).
1. Place the handlebar (40) against the handlebar support (25) and adjust
so that the hole patterns in the handlebar and the handlebar support
are aligned. Put the screw (57) into the hole, push the washer (19) , the
spring washer (72) on screw end and tighten firmly with the handgrip
nut (62).
15