Christopeit Sport CPS 2 Notice De Montage Et D'utilisation page 14

Assembly Instructions
Before beginning assembly, be sure to observe our recommendations
and safety instructions.
Step 1:
Install of the front footbar (21) and the rear footbar (15) on the main
frame (1) with the carriage bolts M8x60 (17), the washers 8//20 /19),
the spring washers for M8 (72) and the cap nuts M8 (18).
1. Place screws (17) and two each washers (19), spring washers (72)
and nuts (18) accessibly beside the front and rear parts of the main
frame (1).
2. Insert the footbars (21) + (15) in the holder of the main frame (1) and
adjust so that the hole patterns of the holders and the footbars (21) +
(15) are aligned.
3. Push one screw (17) through each hole.
4. Fit the screw ends of (17) with one washer (19) and one spring washer
(72) each and fasten with a nut (18).
(Note: If the machine is placed for training on an uneven floor, this can
be compensated at any tome by turning the eccentric caps (16).
Step 2:
Installation of the right pedals (13) and the left pedals (14) on the pedal
crank.
1. The pedals are marked "R" for right and "L" for left.
2. Screw the right pedal (13) into the threaded hole on the right hand side
of the pedal crank (9) and tighten firmly.
(Note: Right and left are specified as viewed seated on the machine
during training. It must also be observed that the threaded part of the
right pedal must be screwed clockwise into the threaded hole of the
pedal crank.)
3. Screw the left pedal (14) into the threaded hole on the left hand side of
the pedal crank (9) and tighten firmly.
(Note: The threaded part of the left pedal must be screwed
anticlockwise into the threaded hole of the pedal crank.)
Step 3:
Installation of the saddle (52) on the saddle support (49) with the wash-
ers 8//20 mm (51) and the self-locking nuts M8 (50).
1. Place the saddle (52) with the seat surface downwards.
2. Place the retaining plate of the saddle support (49) on the upwards
pointing bottom of the saddle (52). The threaded pieces on the bottom
of the saddle must project through the corresponding holes in the
retaining plate of the saddle support (49).
3. Place washers (51) on the threaded pieces, screw on nuts (51) and
tighten firmly.
14