Faq; Light Signals; Sound Signals - CISA 1.E0000.00.0 Notice D'installation Et D'utilisation

FAQ

FAQ Action
On
When I turn the motor on, it
emits a sound signal that lasts 3
#1
seconds.
Possible cause:
Damaged firmware
On
When I turn the motor on, it
emits 3 long sound signals
#2
Possible cause:
Has not reverted to the correct
starting position
Lock blocked
After locking the door with the
key, I can't get it to open with the
motor
#3
Possible cause:
In some kinds of locks, the key
prevents the rod from sliding
freely and, as a result, the door
cannot be opened with the motor
Error rod sensors
During motor movement, it
emits one long sound signal
#4
Possible cause:
L a t c h b o l t / d e a d b o l t s n o t
withdrawn properly
Motor timeout error
After 5 seconds from opening
signal, it emits two long sound
signals
#5
Possible cause:
The motor is not in the correct
position
Locks remains open in hold
open mode
The lock does not close after
#6 giving the opening command
Possible cause:
Opening impulse still active
Locks remains open in hold
open mode
#7
Possible cause:
Opening time set to 180 s

Light signals

Sound signals

(LEDs inside
1 error signal
Red LED on
(3 sec ON)
3 long sound signals
(0.5s ON- 0.5s OFF) Red LED on
3 error signals
(0.5s ON- 0.5s OFF) Red LED on
1 error signal
(0.5s ON- 0.5s OFF) Red LED on
2 error signals
(0.5s ON- 0.5s OFF) Red LED on
- Yellow LED on
- 33 -
the motor)
Call technical assistance to
upgrade FW
or replace the motor
Call technical assistance
or replace the motor
Open the lock with the key to
enable the motor again
Check rod is sliding properly.
Loosen motor screws.
Call technical assistance
or replace the motor
T h e l o c k r e m a i n s o p e n
because it is still receiving an
opening command. Connect
t h e w i r e s a s s h o w n i n
diagram 1 (page 28).
Check the system.
Check settings on PC
IT
Possible
solution
EN
FR
ES
DE
GR
RU
PL