dB Technologies DVX HP Série Mode D'emploi page 5

7
DESCRIPTION
The speakers of DVX HP series use cutting edge digital amplifiers of the DIGIPRO G2
series, providing with different powers 800W, 1200W and 1400W, to meet the
requirements of any kind of application.
These highly efficient amplifiers provide high power with limited weight and dimension.
Thanks to the low power dissipated, the cooling of the amplifier module does not require a
fan.
The digital preamplifier with DSP (Digital Signal Processing) controls the audio crossover
of the acoustic components, the frequency response, the limiter, and the acoustic phase
alignment. A selector enables to select one of two different equalizations - "FULL
RANGE" or "STAGE MONITOR" - to provide high versatility for the different applications.
The amplifiers DIGIPRO G2 use power supplies featuring SMPS (Switched-Mode ®
Power Supplies) technology.
This technology increases power supply efficiency and minimizes its weight.
DXV D8 HP
The D8 HP bi-amped active speaker is equipped with a
®
DIGIPRO amplifier delivering 800W.
D8 HP is a bi-amped speaker features a woofer 8" (voice coil
2") and a compression driver 1" (voice coil 1.4") on a 90°x70°
aluminium CD- horn.
The speaker's horizontal directivity is 90° by default factory
setting.
The speaker is made of 12mm birch ply wood, the one top
handle housing, the 6 flytracks, the 10 M8 threads and the 2
flypins located on the sides and the back of the speaker are
enabling easy transport and installation.
The speaker has been designed to be used also as stage
monitor (45° angle). By rotating the horn you can maintain the
same coverage angle also when the speaker is used as
monitor.
In the bottom of the box there is a standard pole mount cup
(D36mm) made of aluminium.
DVX D10 HP
The D10 HP bi-amped active speaker is equipped with a
®
DIGIPRO G2 amplifier delivering 1200W.
D10 HP is a bi-amped active speaker features a woofer 10"
(voice coil 2,5") and a compression driver 1" (voice coil 1,75")
on a 90°x70° aluminium CD- horn.
The speakers' horizontal directivity is 90° by default factory
setting.
The speaker is made of 12mm birch ply wood, the one top
handle in aluminum , the 6 flytracks, the 6 M10 threads and
the 2 flypins located on the sides and the back of the speaker
are enabling easy transport and installation.
The speaker has been designed to be used also as stage
monitor (45° angle). By rotating the horn you can maintain the
same coverage angle also when the speaker is used as
monitor.
In the bottom of the box there is a standard pole mount cup
(D36mm) made of aluminium.
®
8