Channel Mode Setting; Address Setting; Dmx 512 Configuration - ACME Xperior XP 15R SZ Notice D'utilisation

7.2 Channel Mode Setting

Enter menu mode, select DMX Functions, press the ENTER button to confirm, use the UP and DOWN button
to select DMX Channel Mode, press the ENTER button to confirm, present channel mode will blink on the
display, use the UP and DOWN button to select Mode1 (23 channels mode), press the ENTER button to store.
Press the MENU button back to the last menu or idling let the unit idle one minute to exit menu mode.

7.3 Address Setting

If you use a universal DMX controller to control the units, you have to set DMX address from 1 to 512 so that
the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button to confirm, use
the UP and DOWN button to select DMX Address, press the ENTER button to confirm, the present address will
blinking the display, use UP and DOWN button to adjust the address from 0 to 512, press the ENTER button to
store. Press the MENU button back to the last menu or idling let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
23 channels

7.4 DMX 512 Configuration

Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 seconds, then the corresponding function will take
into effect
23 channels mode:
Unit 1 Unit 2
Address Address
1
Unit 3
Address
24 47
Unit 4
Address
70
41