Error Information - ACME Xperior XP 15R SZ Notice D'utilisation

 Prism—Prism home position adjustment
Enter offset mode, Select Prism, press the ENTER button to confirm, the present position will blink on the
display, use the UP and DOWN button to offset the value from 0 to 255, press the ENTER button to store. Press
the MENU button to exit.
 R-Prism—Prism rotation home position adjustment
Enter offset mode, Select R-Prism, press the ENTER button to confirm, the present position will blink on the
display, use the UP and DOWN button to offset the value from -128 to 127, press the ENTER button to store.
Press the MENU button to exit.
 Zoom—Zoom home position adjustment
Enter offset mode, Select Zoom, press the ENTER button to confirm, the present position will blink on the
display, use the UP and DOWN button to offset the value from 0 to 255, press the ENTER button to store. Press
the MENU button to exit.
 Focus—Focus home position adjustment
Enter offset mode, Select Focus, press the ENTER button to confirm, the present position will blink on the
display, use the UP and DOWN button to offset the value from 0 to 255, press the ENTER button to store. Press
the MENU button to exit.
 Frost—Frost home position adjustment
Enter offset mode, Select Frost, press the ENTER button to confirm, the present position will blink on the
display, use the UP and DOWN button to offset the value from 0 to 255, press the ENTER button to store. Press
the MENU button to exit.

6.4 Error Information

Lamp Startup Fail : it appaears when there is no lamp or some wires are damaged.
Temperature Sense Error : It appears when temperature check board is damaged.
Lamp Too Hot Power Off : It appears when temperature is detected higher than 110℃. Check if the unit is
properly ventilated, or fans or temperature check board may is damaged
Lamp Too Hot Low Power : It appears when detected temperature is higher than 105℃. the unit will run on a
low power level.
Maintenance Fixture : It appears when the maintenance remaining time becomes 0S, please enter menu mode
and reset the time
Lamp On Over 700 Hour : It appears when the lamp always has been on over 700 hours, please turn off the
lamp.
Memory Initial Fail : It appears when the memory IC is damaged.
CPU-B Error, CPU-C Error, CPU-D Error: They appear when board P.C or some wires are damaged
Pan Reset Error, Pan Encode Error, Tilt Reset Error, Tilt Encode Error, Shutter Reset Fail, Dimmer
Reset Fail, Color Reset Fail, Cyan Reset Fail, Magenta Reset Fail, Yellow Reset Fail, Gobo 1 Reset Fail, R-
gobo 1 Reset Fail, Gobo 2 Reset Fail, Iris Reset Fail, Effect Reset Fail, R-effect Reset Fail, Frost Reset Fail,
Flat Reset Fail, Focus Reset Fail, Zoom Reset Fail
They may appear when turning on or resetting the unit, for some parts such as board P.C are damaged. Please
contact the qualified maintenance
39