How To Set The Unit; Power On Display; Main Function - ACME Xperior XP 15R SZ Notice D'utilisation

6. HOW TO SET THE UNIT

6.1 Power On Display

Every time you turn on the unit, it will run built-in program to reset all motors to their home position, the display
will show as fig.1, you may hear some noises for about 20 seconds. It will show warning sign if it goes wrong
during resetting and you can press the MENU button to view the error information. After that the unit will be
ready to receive DMX signal and the display will show as fig.2.
Explanation of fig.2
Base 30℃
Md.1 23Ch.

6.2 Main Function

Turn on the unit, press MENU button into menu mode, and press UP and DOWN button until the required
function is shown on the monitor. Select the function by ENTER button. Use UP and DOWN button to choose
the submenu, press the ENTER button to store and automatically return to the last menu. Press MENU button or
let the unit idle one minute to exit menu mode.
In the event of disconnecting with mains power, press UP button for one minute to enter into menu mode. Press
MENU button or let the unit idle one minute to exit.
The main functions are shown below（the grayed boxes are preset settings）:
Present temperature of base CPU is 30℃
Present start address
001
Present channel mode is mode 1 (23 channels mode)
30