Installations - ACME Xperior XP 15R SZ Notice D'utilisation

Caution：

To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.

Hot lamp explosion hazard. Do not open the unit within 15 minutes after switching off.

DO replace the bulb once it is damaged, deformed or life-expired.

DO NOT look directly at the light while the bulb is on.

Never touch bulb with bare fingers, as it is very hot after using.

DO NOT start on the unit without bulb enclosure or when housing is damaged.
Product Items：
- User manual FR-ENG
- 2 x Omega clamps

2. INSTALLATIONS

Unpacking the fixture (for flight case pack only)
1. Stop the flight case via the brake sheet above the wheels.
2. Unlock the lock modules and open the cover board.
3. Prop the cover board with lid bracket.
4. Take out the fixture.
5. Unlock the lock module take out omega clamps.
Installations:
1. Bolt each clamp (1) to the Omega holder with screw and lock nut through the hole in the holder.
2. Fasten the omega holders (2) on the bottom of the base by inserting quick-lock fasteners (3) into the holes
of the base and tighten fully clockwise.
3. Hang the fixture to the support (4) through clamp and fasten the screws (5). Fasten the safety cable (6)
through the bottom of the base and over the support.
Attentions:

Always ensure that the structure to which you are attaching the unit is secure and is able to support a weight
of 10 times of the unit's weight without any harming deformation.

Make absolute sure that the unit is firmly fixed in way that no vibrating or slipping would occur during
operation.

The equipment must be installed beyond the areas where persons may walk by or be seated.

The rigging has to be operated by or under the guide of the skilled person.
Fig.1 Fig.2
26