Gobos And Lamp; Gobos; Light Source - ACME Xperior XP 15R SZ Notice D'utilisation

5. GOBO AND LAMP

5.1 Gobos

Install the gobos with the device switched off only. Unplug from
CAUTION: never unscrew the screws of the rotating gobo as the

5.2 Light source

Philips MSD Platinum 15R

Because of its high internal pressure, there might be a risk that the Discharge lamp would explode
during operation. The lamp emits intense UV radiation which is harmful to the eyes and skin. The
high luminance of the arc can cause severe damage to the retina if you take a close look at the
lamp.

To protect the lamp, always turn off the lamp first (via control panel or DMX controller) a nd let
the unit run at least five minutes to cool down before switching off the mains supply. Never handle
the lamp or luminary when it is hot.

Do not touch the bulb with bare hands. If this happens, clean the lamp with denatured alcohol and
wipe it with a lint free cloth before installation.

The lamp generates UV radiation. Never operate the lamp without appropriate shielding.

When lighting up, the lamp operates at high pressure and there is a slight risk of arc tube rupture. The
risk increases with age, temperature and improper handling of the lamp. Do not use the lamp longer
than its lifespan.

Make sure the lamp is located in the center of the reflector for the best projection
DANGER !!!
mains before changing gobos.
ball bearing will otherwise be opened.
29