ACME Xperior XP 15R SZ Notice D'utilisation page 35

 State/Power On—Lamp state while power on
Select State/Power On, press the ENTER button to confirm, present mode will blink on the display, use
the UP and DOWN button to select On (Lamp on while power on) or Off (Lamp off while power on),
press the ENTER button to store. Press the MENU button back to the last menu or let the unit idle one
minute to exit menu mode.
 Off Via DMX—Turn off the unit via DMX controller
Select Off Via DMX, press the ENTER button to confirm, present mode will blink on the display, use the
UP and DOWN button to select Yes (turn off the unit via DMX controller available) or No (turn off the
unit via DMX controller impracticable), press the ENTER button to store. Press the MENU button back to
the last menu or let the unit idle one minute to exit menu mode.
(When you operate the unit via DMX controller, set the value of channel "special function" to "lamp off",
waiting for 5 seconds, then the lamp will be off if you choose "yes" mode).
 On If DMX On—Lamp turns on when DMX signal is detected
Select On If DMX On, press the ENTER button to confirm, present mode will blink on the display, use
the UP and DOWN button to select Yes (Lamp turns on when DMX signal is detected) or No (keep the
present state), press the ENTER button to store. Press the MENU button back to the last menu or let the
unit idle one minute to exit menu mode.(If the lamp is off via DMX signal, you can reconnect the DMX
controller to make the lamp on).
 Off If DMX Off—l Lamp turns off when DMX signal is cut off
Select Off If DMX Off, press the ENTER button to confirm, present mode will blink on the display, use
the UP and DOWN button to select Yes (Lamp turns off when DMX signal is cut off), press the ENTER
button to store. Press the MENU button back to the last menu or let the unit idle one minute to exit menu
mode.
 Cooling Mode—Control the speed of fans
Select Cooling Mode, press the ENTER button to confirm, present mode will blink on the display, use
the UP and DOWN button to select Auto (fans speed adjust automatically) or High (fans run in high
speed), press the ENTER button to store. Press the MENU button back to the last menu or let the unit idle
one minute to exit menu mode.
 Ignition Delay—Delay time between power on and lamp on
Select Ignition Delay, press the ENTER button to confirm, present mode will blink on the display, use the
UP and DOWN button to adjust the delay time from 0S to 255S, press the ENTER button to store. Press
the MENU button back to the last menu or let the unit idle one minute to exit menu mode.
 Low Power Delay—Delay time between reduce lamp power and shutter off the unit
Select Low Power Delay, press the ENTER button to confirm, present mode will blink on the display, use
the UP and DOWN button to adjust the delay time from 0S to 255S, press the ENTER button to store.
Press the MENU button back to the last menu or let the unit idle one minute to exit menu mode.
(If you set the low power delay time to 3S, the lamp will run in half power 3 seconds after the unit shutters
off)
34