Switching On And Off; Working With The Lawnmower; Cleaning, Maintenance And Storage - Grizzly ERM 1434-3 Stow Traduction De La Notice D'utilisation Originale

Switching On and Off

1. Plug the mains lead into the ap-
pliance's power inlet (16).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (15).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (17) on the handle at the
same time as pressing the start
lever (2). Release the release
button (17).
6. To switch off, release the start
lever (2).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
The two handles (see 12) make it
easier to carry the appliance.
• Start mowing near the socket and
work away from the socket.
• Always keep the extension cable
behind you and when you turn, move
it to the side that has already been
mowed.
• Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few centi-
metres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when go-
ing backwards and pulling the equip-
ment.
• Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
GB
65