Assembly; Assembling The Curved Handle; Operation; Mounting / Removing The Grass Catcher - Grizzly ERM 1434-3 Stow Traduction De La Notice D'utilisation Originale

GB

Assembly

Disconnect the plug before any
work on the equipment.

Assembling the Curved Handle

Install lower bar:
1. Open the lower bar (4) and
move it to the desired inclinati-
on.
2. Fix the lower bar by means of
the pre-mounted quick-release
levers (6). There are three pos-
sible positions.
Install curved handle:
3. Fasten the bow-type handle
(1) with the enclosed screws,
washers and quick-release le-
ver (3) to the right and left of the
lower bar (4). Two positions are
possible.
4. Clipping in the cable holders
Clip the cable holders (14) onto
the bar to fix the connection
cable (13) in position

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (18) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
64
4. To remove the grass catcher (7),
lift the collision guard (5) and un-
hook the grass catcher from the
mounting bracket. Flap down the
collision guard to the housing.
On emptying the grass catcher
also refer to section "Disposal/
environment".

Level gauge

The level gauge (7a) is located on the
side of the grass catcher (7).
Flap open: grass catcher
(7) empty
Flap closed: grass catcher
(7) full

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(11) and move it to the correct
cutting height, as appropriate.
There are 6 different cutting heights:
25-75 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around
30 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
A higher cut height should be se-
lected for the first cut of the season.