Configuring The System Software; Entering And Exiting Configuration Mode - Dometic RTX1000 Instructions De Montage

RTX1000/2000, SPX1200T
7

Configuring the system software

Before the system is first put into operation, the control unit settings can be
adjusted to suit the various installation conditions. Those adjustments must be
made by the installer (fig. 5).
Display
indication
P.01
P.02
P.05
I
NOTE
Configuration mode can still be activated if the low voltage cut-out has
switched off the system and only residual voltage is available.
7.1

Entering and exiting configuration mode

➤ Press and hold the
➤ Additionally press the
✓ The display shows the symbol
✓ The parking cooler switches to configuration mode.
✓ The display shows "P.01" and the symbol
➤ Scroll through the menu by pressing the
desired menu item.
➤ Press the
➤ Press and hold the
EN
Parameter Meaning
Low voltage The battery monitor shuts down the
shut-down system at the voltage defined here.
Unit for tempera- The temperature can be displayed in
ture display °C or °F.
Tilt sensor The tilt sensor can be calibrated to a
zero setting.
button.
button for longer than 3 s.
button to open the desired menu item.
button for longer than 3 s to exit configuration mode.
Configuring the system software
.
flashes.
or button to select the
Factory
setting
22.8 V
°C
–
13