Configuration Via Button; Configuration Via Pseudo Cv Address; Cvs For Pseudo Cv Programming - Roco Z21-Detector X16 Manuel D'utilisation

Z21 Detector X16
®_

Configuration via button

Connect the Z21 - Detector X16 to the R-Bus and supply track voltage of the control panel to the track
®
inputs P and N of the Z21
The blue "Status" LED flashes briefly and does not light up permanently until you have connected the
Z21 - Detector X16 to the R-Bus. Press the programming button on the Z21
®
second; the white program LED starts to flash. Activate a magnet article with the address of your choice
within the next minute. The magnet article can be activated using the Z21
such as the MULTIMAUS. The address has been accepted by the Z21
gram LED has stopped flashing.

Configuration via pseudo CV address

Connect the Z21 - detector X16 to the Z21
®
Z21 - detector X16 with the track voltage from the control centre.
®
If you have correctly connected the Z21
"Z21 Maintenance Tool" in the CV programming tab, the WLAN-MULTIMAUS
®
multiMAUS (if using a multiZENTRALE
pro
pseudo "loco address" 9819. If you happen to own a real locomotive with this address, please remove
it from the track before.
Before programming a CV, the programming button on the Z21
least 1 second (but no more than 2 seconds). The white LED then flashes for a maximum of one minute to
show that the module is waiting for CV programming. As soon as a CV has been received or the waiting
time has elapsed without receiving a CV, the programming mode is ended and the white LED goes out.

CVs for pseudo CV programming

CV Description
99 Module address
100 Current threshold
101 Response time
102 Fall time
22
22
8010819920 .indd 22
- Detector X16.
®
via the R-Bus and provide the track inputs P and N on the
®
- Detector X16, you can either use the configuration software
®
) in the PROGRAMMING menu | Configure CV CHANGE via the
pro
Note
0 = adress 1
1...20 = adress 1...20,
21...255 = invalid (address not being changed)
0 = 0,5 mA, 1 = 1mA,
2 = 2mA, ..., 70 = 70mA, 71...255 = 70mA
0 = 10ms, 1 = 10ms, 2 = 20ms, ..., 16 = 160ms,
17...255 = 160ms
0...255 = 0...2550ms
- detector X16 for at least 1
®
App or another input device
®
- detector X16 after the white pro-
®
, the MULTIMAUS
®
- Detector X16 must be pressed for at
®
Factory setting
1 (adress 1)
4 (4mA)
1 (10ms)
10 (100ms)
or the
®
07.01.2019 09:38:58