Connect Z21 ® - Detector X16 To The Control Panel; Connection Via R-Bus; Configuration - Roco Z21-Detector X16 Manuel D'utilisation

Connect Z21
You can connect the Z21
ZENTRALEpro.

Connection via R-Bus

Z21
®

Configuration

NOTE: The module address assignment for the occupancy detector must not create "address
gaps", i.e. the individual module addresses must be assigned in consecutive numbering. It should
also be noted that a Z21
ed per 8 occupancy detection inputs. When assigning addresses, only the first of these two mod-
ule addresses should be assigned, the second and immediately following address is determined
independently by the occupancy detector.
EXAMPLE: Two occupancy detectors type 10819, one type 10808 as well as another one
type 10787 should get configured. The order on the layout is the following: Z21  10819
 10808  10819  10787 (See image in chapter "Connection via R-Bus")
If no occupancy detector module address has yet been assigned, then the first occupancy detector
receives the address "1", which leads to an internal assignment of the two module addresses
"1" and "2". Next, assign the address "3" to the occupancy detecotr 10808. After that, by
assigning the address "4" to the second occupancy detector 10819, the module address pair "4"
and "5" can be assigned. Finally assign the address "6" to the occupancy detecor 10787.
8010819920 .indd 21
- Detector X16 to the control panel
®
- Detector X16 via the R-Bus interface on all Z21
®
10819 10808
- Detector X16 uses two consecutive addresses, as one address is need-
®
control panels and the multi-
®
10819 10787
Z21 Detector X16
®_
usw.
21
07.01.2019 09:38:58