Vortice REG FILTER Notice D'emploi Et D'entretien page 32

Record 15: UV-C lamp control
[read / write].
High byte: Enable / disable UV-C
lamp.
0: UV-C lamp disabled.
1: UV-C lamp enabled (operation according to schedule,
Registro 16). Activation only if purifier on (fan on, Record 51  0).
Fan speed = Record 3. 2: UV-C lamp enabled (operation
according to schedule, Record 16).
Activation only if purifier on (fan on, Record 51  0). Fan speed = Record 15 (low byte).
3: UV-C lamp enabled (operation according to schedule, Record 16).
Independent activation of the purifier on / off. Fan speed = Record 3.
4: UV-C lamp enabled (operation according to schedule,
Registro16). Independent activation of the purifier on / off. Fan
speed = Record 15 (low byte). Default value: 0 [UV-C lamp
disabled].
Low byte: Fan speed with activated UV-C lamp.
The value that is sent is the rate value (20% to 100%) in 16-bit binary.
Default value: 30 [30%].
Valid for when Record 15 (high byte) = 2 or Register 15 (high byte) = 4.
Record 16: UV-C lamp schedule [read /
write]. High Byte: Start time.
The value that is sent is the time value (0h to 23h) in 16-bit binary.
Default value: 19 [19:00].
Low byte: End time.
The value that is sent is the time value (0h to 23h) in 16-bit binary.
Default value: 6 [6:00].
Registers 17 and 18: Identifier [read / write].
The value that is sent is the value of the identifier in binary 16 bits.
Default value: 0 [0].
The display is 5 digits of 7 segments: 20 bits.
32