Display Lcd - Vortice REG FILTER Notice D'emploi Et D'entretien

-Schedule settings (PrOG): With MODE the data to be modified (day / period / setpoint) is selected, and with UP and DOWN
the corresponding value is modified (time / setpoint). To deactivate the period, set the time to value: -. ON / OFF exits the time
schedule configuration, returning to normal operating mode. See the REG FILTER regulator time schedule.
- Identifier display (ıd): The identifier configured in the regulator is displayed through serial communication.
The display is made by 5 digits of 7 segments: O 1 2 3 4 5 6 7 8 9 A b C d E F
- Parameter mode (PAr): With MODE the parameter to be displayed is selected, and with UP and DOWN its value is modified.
With ON / OFF the parameter mode is exited, returning to the normal operating mode. See REG FILTER regulator parameters.
- Reset of filter G4 operating time (r g4): When entering this mode, the current operating hours of the G4 filter are displayed.
To reset the operating time (for example, resetting the hours by changing the filter), press ON / OFF. As confirmation of the reset
of the operating time, the display shows "HG OOOOO", returning to the normal operating mode. If ON / OFF is not pressed, after
a few seconds the regulator returns to normal operating mode without having reset the operating time.
- Reset del tiempo de funcionamiento del filtro H14 (r H 14): Upon entering this mode, the current operating hours of the H14
filter are displayed. To reset the operating time (for example, resetting the hours by changing the filter), press ON / OFF. As
confirmation of the reset of the operating time, the display shows "HH OOOOO", returning to the normal operating mode. If ON /
OFF is not pressed, after a few seconds the regulator returns to normal operating mode without having reset the operating time.
- Controller reset (rESET): When the regulator is reset, the display shows "-----", starting operation again after a few seconds.

DISPLAY LCD

Note: When powering the regulator, or after resetting it, it displays the following on the display:
• rP143 + : REG FILTER regulator indication
• v X.X: Indication of the controller firmware version.
• wAit: Indication that the regulator is in the initialization process.
88888
D1 D2 D3 D4 D5
22