Velleman MA620B Notice page 4

B. MOUNTING CONTROL MODULE:
The control module should be mounted in the storage box under the seat. The module may be
secured by Velcro tape or with screws. Insure that the module is completely secure and will
not rattle or come loose.
NOTE :
1. Install the control module on the best chance of remaining dry, free from grease and
dirt, away from the engine and exhaust system.
2. Antenna placement is very important! Ensure that it is unwrapped and stretched out
with the last 6"straight, as for from metal as possible.
C. INSTALLING THE LED STATUS INDICATOR :
There must be at least 5/8" of distance behind the mounting location as the LED housing will
extend back that far. Once a suitable location is chosen, drill a 6mm hole. Run the LED wires
through the hole then press the LED housing into the place.
D. INSTALLING THE OVERRIDE / VALET SWITCH :
Mount the override/valet switch in a hidden bus accessible location. Drill a ¼" hole at the
location chosen and use the nut and lock washer provided to secure the override switch. Do
not mount the switch where it will get greasy or damaged by moving parts.
Keep wiring away from moving engine parts, exhaust pipes and high tension cable. Tape
wires that pass through holes on the fire wall to prevent fraying. Watch out sharp edges that
may damage wires and cause short circuit.
CAUTION : Do not connect the wire harness to control module until all wiring to vehicle is
completed.
A. 11-WIRE HARNESS
1. GREEN WIRE -- GROUND TRIGGER INPUT --
This wire is the ground trigger input wire for other sensor to use with the alarm.
2. & 3. YELLOW WIRE – IGNITION DISABLE WIRE --
Find the wire coming form the ignition key that supplies power to ignition coils. Cut the
wire in half and push the start button. The engine will not start, if you found the correct
wire. Then connect one yellow wire to half of ignition wire and connect the other yellow
wire to another cut half of ignition wire.
4. BLACK WIRE – SYSTEM GROUND –
This is the main ground connection of alarm module. Connect it to a solid section of the
motorcycle ground and secured it to ensure a good chassis connection.
5. GRAY WIRE – OVERRIDE / VALET SWITCH WIRE --
Connect the grey wire to any one of the wire from override/valet switch, then connect the
other wire from the override switch to ground.
6. RED WIRE – SYSTEM POWER (+12V CONSTANT) –
The red wire supplies power to the system. Connect this wire to a constant + 12V source
from battery.
7. & 9. WHITE WIRES – FLASH PARKING LIGHT (+12V 5A OUTPUT)--
When the alarm is triggered, these wires will provide pulse + 12 volts, 5 amps output.
Connect one of the two white wires to right light of turning indicators and connect the
other wire to left indicator.
MA620B
WIRING
4 VELLEMAN