Velleman MA620B Notice page 10

Most of alarms will be disarmed when the car battery disconnected and then re-connected
immediately. However, this alarm will be armed not disarmed. This is to prevent the thieves
steal your motorcycle once he disconnect motorcycle battery and re-connect.
1. When the system is on valet switch 'off' and ignition switch 'off' condition, once reconnect
the power, the system will be armed and panic.
2. When it is on valet 'on' condition, once reconnect the power, 3 chirps from alarm, and the
system will be in valet mode.
3. When it is on ignition 'on' condition, once reconnect the power the system will be disarm.
M. TRANSMITTER BATTERY REPLACEMENT :
If the range of your transmitter deteriorate, it is possible that you need to replace the batter.
1. Release the screw from the back of transmitter and remove upper transmitter case with a
screwdriver.
2. Remove old battery from transmitter.
3. Install a new battery (12 volt) noting the (+) and (-) marks in the battery area of the
transmitter.
4. Replace upper transmitter case with care, don't damage the inside components.
5. Tighten the screw on the back of transmitter.
MA620B 10 VELLEMAN