Livestrong LS8.0E Manuel Du Propriétaire page 21

ASSEMBLY STEp 8
lS13.0E SHOWN
HANDLEBAR WIRE
CONSOLE
CONSOLE MAST
All manuals and user guides at all-guides.com
AERO HAND GRIPS
(LS13.0E only)
CONSOLE CABLES
UPPER HANDLEBAR
BOLTS (BB)
PRE-INSTALLED
SET SCREWS
HANDLEBAR WIRES
LOWER HANDLEBAR
NOTE: Be careful not to pinch
any wires while attaching the
console or handlebars.
HARdWARE bAG 8 CONTENTS :
A Open hardware bag 8.
B Attach the console cables to the console.
C Carefully tuck the console cables into the console
mast before attaching the console. Attach console to
console mast using 4 bolts (bb).
D LS13.0E ONLY: Carefully pull the handlebar wire from
the aero hand grip through the upper handlebar
using the twist tie located inside the upper handlebar and
then discard the twist tie. Pull the handlebar wire from the
bottom of the upper handlebar while sliding the aero
hand grip onto the upper handlebar to prevent the
handlebar wire from becoming pinched and create slack
to connect the wire. Connect the Handlebar wire from the
upper handlebar to the wire from the console mast.
E Slide upper handlebar onto lower handlebar making
sure handlebars are joined together completely. Secure upper
handlebar to lower handlebar using pre-attached
set screws.
Make sure upper handlebars are as far down as possible.
Handlebars can be damaged If not secured correctly.
F Repeat steps D–E on other side.
LS8.0E, LS10.0E ASSEMBLY COMPLETE!
BOLT (BB)
12 mm
Qty: 4
Al
MOdE
21