Livestrong LS8.0E Manuel Du Propriétaire page 15

ASSEMBLY STEp 3
lS10.0E SHOWN
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
& WASHERS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
GUIDE RAIL
PEDAL ARM WHEEL
All manuals and user guides at all-guides.com
CRANK
PEDAL ARM
WAVY WASHER (L)
FLAT WASHER (K)
SPRING WASHER (B)
BOLT (M)
HARdWARE bAG 3 CONTENTS :
WAVY WASHER (L) BOLT (M)
22.5 mm 20 mm
Qty: 2 Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
Attach console mast to main frame
C
using pre-installed bolts and
washers.
Slide wavy washer (l) over cranK
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the cranK using 1
E
flat washer (K), 1 spring washer (b)
and 1 bolt (m).
Repeat steps D–E on the opposite side of the
F
elliptical.
SPRING WASHER (B) FLAT WASHER (K)
15 mm 20 mm
Qty: 2 Qty: 2
Al
MOdE
15