Description And Use; Safety - Vortice CA WE Notice D'emploi Et D'entretien

ENGLISH

Description and use

The product you have purchased is an axial
centrifugal aspirator used to ventilate rooms with
single channel exhaust. The product avoids
traditional installations inside rooms, avoids air return
when the unit is off, and softens room noise as it is
installed outside the wall.
IMPORTANT: The unit is able to develop 3 ventilation
speeds, as it is already equipped with suitable
condensers. Operating speed control is designated
to pairing with an appropriate 3-speed selector. For
further information regarding the control device, see
the "Wiring diagrams" paragraph.

Safety

Before proceeding, follow the instructions provided in
the "Safety and disposal warning" booklet provided
together with this product.
Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Always use the product for the purpose it was
intended, as specified in this booklet.
• After removing the product from its packaging,
ensure that it is not damaged. If in doubt please
contact a Vortice authorised Technical Assistance
Centre immediately. Never leave packaging parts
within reach of children or disabled persons.
• The use of any electric device requires compliance
with a few fundamental rules, including:
- Never touch it with wet or humid hands.
- Never touch it when barefoot.
- Do not allow use by unsupervised children or
disabled persons.
• Store the device away from children and persons
with disabilities when you decide to disconnect it
from the power supply and not to use it any more.
• Do not use the unit in the presence of flammable
substances or vapours
insecticides, gasoline, etc.
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make changes of any kind to the unit.
• Do not rest objects on the device.
• Periodically check
imperfections are noted, do not use the unit and
immediately contact a Vortice authorised Technical
Assistance Centre.
• Promptly contact a Vortice authorised Assistance
Centre in the event of unit malfunction and/or failure
and request the use of original Vortice spare parts
for any repairs.
• If the unit falls or receives a strong blow,
immediately have it inspected at a Vortice
authorised Technical Assistance Centre.
• Only connect the device to the mains supply/
electrical outlet if plant/outlet capacity is suitable for
its maximum power. If otherwise, immediately seek
8
such as alcohol,
device conditions.
assistance from a professionally qualified person.
• Switch off the main switch on the system when: a)
a malfunction is detected, b) you decide to perform
external cleaning maintenance, c) when you decide
not to use the device for prolonged periods.
• It is essential to ensure that sufficient air re-enters
the room, in order to guarantee product operation.
If a combustion-powered, non air-tight device is
installed in the room (water heater, methane stove,
etc.), please ensure that air re-entry also guarantees
the perfect combustion of said device.
• The unit cannot be used as an activator for water
heaters, stoves, etc. nor should it discharge into hot
air ducts.
• The unit must be correctly connected to an effective
earthing system as foreseen by current electrical
safety regulations. If doubts should arise, request
careful inspection by qualified personnel.
• The unit must discharge directly outside.
• The air flow to convey (or fumes) must be clean (or
rather free of grease, soot, chemical and corrosive
substances or explosive and flammable mixtures).
• Never cover or obstruct the unit delivery grille to
ensure optimal air passage.
• The electrical specifications correspond to the ones
on the data label A (fig.A).
If