Description And Use; Safety - Vortice CA MD W Notice D'emploi Et D'entretien

Masquer les pouces Voir aussi pour CA MD W:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
ENGLISH

Description and use

The product you have purchased is a metal axial
centrifugal fan with free aspiration or in ducts and free
delivery. IMPORTANT: The unit is able to develop 3
ventilation speeds, as it is already equipped with
suitable condensers. Operating speed control is
designated to pairing with an appropriate 3-speed
selector. For further information regarding the control
device, see the "Wiring diagrams" paragraph.
These appliances are designed
for
use
in
commercial properties.

Safety

Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Always use the product for the purpose it was
intended, as specified in this booklet.
• After removing the product from its packaging, ensure
that it is not damaged. If in doubt please contact a
Vortice authorised Technical Assistance Centre
immediately. Never leave packaging parts within
reach of children or disabled persons.
• The use of any electric device requires compliance
with a few fundamental rules, including:
- Never touch it with wet or humid hands.
- Never touch it when barefoot.
- Do not allow use by unsupervised children or
disabled persons.
• Do not use the unit in the presence of flammable
substances or vapours such as alcohol, insecticides,
gasoline, etc.
This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
Children shall not play with the
appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
Precautions must be taken to
residential
and
prevent gas coming from the gas
flue pipe or from other fuel
combustion units from entering
into the room.
Products installed without a
protective device for moving
parts must be installed at a
height greater than 2.3 m above
the floor level.
Units equipped with manual
reset thermal breaker device
In order to avoid any danger of
accidental reset of the thermal
breaker device, units must not be
powered by an external switch
device such as a timer, or must
not be connected to a circuit that
is
regularly
disconnected from power utilities
powered
or
9

Publicité

Table des Matières
loading

Table des Matières