Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Typical applications
See Figures 1-6;
The images shown refer to typical applications for this
product.
In particular, in Figure 1, it is possible to check the
correct orientation of the product from duct:
A = intake
B = delivery
Installation
See Figures 7-10.
The images shown are purely indicative.
purpose is to illustrate the main assembly steps for the
entire range.
IMPORTANT: See the "Wiring Diagrams" paragraph to
check the 3 ventilation speeds.
IMPORTANT
If the aspirator is mounted at a height less than or
equal to 2.3 m from the floor, it is mandatory to install:
• the frame with external safety net (fig.6) or the
gravity shutter (fig.5);
• the internal fixed protective grid in case the
appliance is not intubated (fig.4).
Wiring diagrams
See Figure 11A.
Connection with the optional device upon request is
foreseen to check ventilation speeds (device not
supplied in packaging):
- 11A) Vortice 3-speed selector Code 12.869.
IMPORTANT
Vortice guarantees correct product operation and
control only when paired with the Vortice 3-speed
selector (Code 12.869).
Other types of connection
Alternatively, other connection diagrams are available,
associated to different control modes (devices
provided by the installer).
Connection alternative for new installation
- 11B) Pairing with 3-switch control;
- 11C) Pairing with Electronic dimmer.
Machine replacement on existing system
Connection without modifications to the electrical
system: the same switches as on the existing system
will be used. CAUTION: it will not be possible to
connect all 3 available speeds but only those for which
the electrical system is set up (to be chosen by the
installer):
- 11D) Speed connection: Minimum and Maximum;
- 11E) Speed connection: Medium and Maximum.
CAUTION
Correct operation of ERP 2018 is only guaranteed
when set in compliance with the connection diagram
11A).
Maintenance / Cleaning
Fig 12-14.
Important information
concerning the
Their
environmentally compatible
disposal
This product complies with Directive 2012/19/EU on
the management of waste electrical and electronic
equipment (WEEE).
The crossed-out wheeled bin symbol on
the appliance indicates that, at the end of
its useful life, the product must be taken to
a specialised company for transport and
treatment. This company will take care of
the disposal of the various materials
making
up
subsequent proper recycling.
Alternatively, the manufacturer of the appliance is
obliged to take back the product to be disposed of in
exchange for the purchase of an equivalent appliance.
the
product
and
their
11
Publicité
Table des Matières
