Connection And Assembly; Technical Data; Maintenance/Cleaning - Vortice FILTER BOX FB 1200 Notice D'emploi Et D'entretien

ENGLISH

Connection and assembly

The FB filter must be installed on a ventilation line,
upstream from the fan/heat recovery sistem,
upstream from the noise attenuator NA, and if
present, upstream from the air heater AH. To install
the air filter, it is sufficient to insert it into the tube (Fig.
1).
1 1
The appliance is connected to the system by means
of a forced insertion on two cylindrical fittings in
galvanised steel with circular rubber built-in "T" seals.
Leave sufficient space to allow the filter to be cleaned
or replaced.

Technical data

Filtering class:
F7
Filtering media:
F7 Filter: composit polypropylene
Max operating temperature:
F7: 70° C
Dimensions: fig 2.
2 2
E
C
D
Mod. A B
235 285
FB 500
405 315
FB 800
FB 1200 470 370
560 485
FB 2000
630 515
FB 2500
710 608,5
FB 4000
FB 6000 710 805
VORT NRG
FB
A
C D E
300 200 400
300 250 400
600 315 700
600 315 700
700 355 800
900 450 1000
900 450 1000
NA
Curves of the initial load loss of filters:
Diagrams pag. 18.

Maintenance/cleaning

Check the filter from time to time and, if necessary,
replace it. Non reconditionable filters, which have to
be replaced when the loss of pressure is 1.5 times
above the loss that occurs when the filter is cleaned.
Clean the filter with mechanical means, a vacuum
cleaner or compressed air.
Kg
6,5
9
16
20
25
34
40
AH
7