Trimmer Adjustment - BFT ARIES Instructions D'utilisation Et D'installation

ENGLISH
INSTALLATION MANUAL
DIP4 Automatic closing time (TCA)
ON: Automatic closing activated (can be adjusted from 0 to 90s).
OFF: Automatic closing not activated.
DIP5 Control logic
ON: 2-step logic is activated (see start paragraph).
OFF: 4-step logic is activated (see start paragraph).
DIP6: Preallarm (mod.ARIES P only)
ON: The flashing light turns on abt 3 seconds before the motors start.
OFF The flashing light turns on simultaneously with the start of the motors.
ATTENTION: Dip non used in mod. ARIES (always in OFF set).

7) TRIMMER ADJUSTMENT

TCA This adjusts the automatic closing time, after which time the gate
automatically closes (can be adjusted from 0 to 90s).
TW This adjusts the motor working time, after which time the motor stops
(can be adjusted from 0 to 40s).
TDELAY This adjusts the closing delay time of the second motor (M2).
8) MOTOR TORQUE ADJUSTMENT
The ARIES control unit has electric torque adjustment which allows the
motor force to be adjusted.
The adjustment should be set for the minimum force required to carry out
the opening and closing strokes completely.
Adjustment is carried out by moving the connection 55 (fig.3) on the tran-
sformer sockets as described below:
Pos.T1 1st TORQUE (MINIMUM TORQUE)
Pos.T2 2nd TORQUE
Pos.T3 3rd TORQUE
Pos.T4 4th TORQUE (MAXIMUM TORQUE)
4 motor torque values can be obtained.
To gain access to the torque adjustment sockets, disconnect the mains
supply and remove the protective case "P" of the transfomer.
CAUTION: Excessive torque adjustment may jeopardise the anti-squash
safety function. On the other hand insufficient torque adjustment may not
guarantee correct opening or closing strokes.
9) MAINTENANCE AND DEMOLITION
The maintenance of the system should only be carried out by qualified
personnel regularly. The materials making up the set and its packing must
be disposed of according to the regulations in force.
Batteries must be properly disposed of.
WARNINGS
Correct controller operation is only ensured when the data contained
in the present manual are observed. The company is not to be held
responsible for any damage resulting from failure to observe the
installation standards and the instructions contained in the
present manual.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product
features unchanged, at any time and without undertaking to update
the present publication.
13
ARIES/ARIES-P - Ver. 08 -