Stihl KM 94 R Notice D'emploi page 15

Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until engine runs.
N
As soon as the engine runs
At temperatures below +10 °C (+50 °F)
Warm up the engine for at least
10 seconds in position g.
At temperatures above +10 °C (+50 °F)
Warm up the engine for at least
5 seconds in position g.
KM 94 R
Depress throttle trigger lockout and
N
pull the throttle trigger – the choke
knob moves to the Run F position.
Warm up a cold engineat varying
speeds.
WARNING
Make sure the carburetor is correctly
adjusted. The working tool must not
rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Depress the momentary contact
N
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g.
Depress throttle trigger lockout and
N
pull the throttle trigger – the choke
knob moves to the Run F position.
Continue cranking in position F until
N
the engine runs.
Running engine stalls in cold start
position g or under acceleration.
Continue cranking in position F until
N
the engine runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob according to
N
engine temperature.
Now start the engine.
N
English
13