Environmental Conditions; Securing The Elements; Electrical Connections - Erreka VIVO-D102 Manuel De L'installateur

Environmental conditions


Make sure that the place for attachment is firm
enough to withstand the strain of the device.
Electrical power supply installation

Ensure that the current connection and power installation meet the following requirements:
• The nominal voltage of the installation must
coincide with that of the control board.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
3

SECURING THE ELEMENTS

1 Choose a location for the control board, taking as a
reference the figure shown in "Elements of the
complete installation" on page 34.

The height from the ground must be
sufficient as to be out of the reach of children.

The attachment surface must resist the
weight of the control board.
2 Make two holes and attach the control board with
appropriate screws.
4

ELECTRICAL CONNECTIONS


Complete the installation in line with low
voltage regulations and applicable rules.

Use cables with sufficient section, always
earthed.

Check the manufacturer's instructions for all
the elements installed.
O
The operating voltage of the operators and the
control board must match the mains voltage
(230VAC/ 50-60Hz for the VIVO-D102; 125VAC/
50-60Hz for the VIVO-D102M).

This device is not suitable for installation in
inflammable or explosive environments.

Check that the admissible environmental
temperature range for the control board is
suitable for the location.
• The direct connection point must be high
enough to be out of the reach of children.
• The facility must
disconnection device
opening distance that allows complete
disconnection under
established in overvoltage category III.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
3 Attach the other elements of the installation in line
with the corresponding instructions.
4 Position the ducts for the cable, securing them firmly
using appropriate means.

If push buttons are installed to operate the
installation, we recommend installing them
out of the reach of children to prevent them
being played with (minimum recommended
height 1.6 m).
INSTALLATION
be fitted with a
with a contact
the conditions
VIVO-D102 Control board
41