Erreka VIVO-D102 Manuel De L'installateur page 43

Peripheral connections
O
When installing batteries, ensure they are connected through an external
charger (CHG). Do not connect them directly to the control board.
The ADN01 kit is recommended, consisting of a charger and two 12V/1.2Ah
batteries, as it has been designed for use in this control board.
A.T. Total opening key device
SG.C Closing safety device (mechanical strip or
photocell)
SG.A Pedestrian access safety device (circuit
breaker, magnetic contact, etc)
FT Output 24Vdc for photocells (cable
connectors 6 and 7)
AUX Output 24Vdc (cable connectors 7 and 8)
DEST Flashing light (230Vac, 60W max)
LG Garage light (max 2300W resistive)
ANT Antenna connection

We recommend checking
instructions to carry out the connections with
the control board.
R.E.
SCA
STOP
SMF
BAT
ADN01 Charger kit (CHG) + batteries (2x 12V/
the accessory
Plug-in receiver
SCA light (24Vdc)
Release switch (normally closed), installed
only in IZAR operators with encoder and
release
Traffic light card AEPS1-001
Rechargeable batteries (24 Vdc)
1.2Ah)
INSTALLATION
ADN01
43
VIVO-D102 Control board