Automatic Safety Elements; Other Observations - Erreka VIVO-D102 Manuel De L'installateur

5

AUTOMATIC SAFETY ELEMENTS

This device complies with all current safety regulations.
However, the complete system comprises, apart from
the control board referred to in these instructions, other
elements which should be acquired separately.

The safety of the complete installation depends on
all the elements installed. Install only Erreka
components in order
operation.
6

OTHER OBSERVATIONS

• CAUTION: To avoid unexpected connections and
disconnections, the unit should not be powered by
an external operation device such as a timer, nor
should it be connected to a circuit that is regularly
connected and disconnected from the power
supply.
• The commissioning operations specified in sections
"Checking the impact thrust" on page 50 and
"Final checks" on page 50 must be carried out
before using the facility.
to guarantee proper
GENERAL SAFETY INSTRUCTIONS

The installer is responsible for the correct, safe
operation of the facility.

Respect the instructions for all the elements
positioned in the installation.

We recommend installing safety elements.

For further details, see "Fig. 1 Elements of the
complete installation (with IZAR operator)" on
page 34 and "Fig. 2 Elements of the complete
installation (with MAXI operator)" on page 35.
• The manufacturer shall not be liable for any damage
or harm to people, animals, goods or property
resulting from failure to follow the assembly
instructions. The warranty for material defects is
void in such cases.
• The packaging must be discarded in compliance
with local regulations.
• Do not start the system up while automation tasks
are being carried out nearby, as such tasks require
the power supply to be disconnected.

Warnings for installation: see "Initial conditions and
checks prior to installation" on page 40
33
VIVO-D102 Control board