Description Of The Product; Elements Of The Complete Installation - Erreka VIVO-D102 Manuel De L'installateur

DESCRIPTION OF THE PRODUCT

DESCRIPTION OF THE PRODUCT
1

ELEMENTS OF THE COMPLETE INSTALLATION

1 Control board
2 Operator (IZAR with encoder)
3 Traffic light
4 Flashing light
ELECTRICAL CABLING:
Element
A: Main power supply
B: Flashing light
C: Photocell
D: Pushbutton or key switch
E: Operator (motor + encoder)
F: Operator release
G: Antenna
Fig. 1 Elements of the complete installation (with IZAR operator)

The safe and correct operation of the
installation is the responsibility of the installer.
34
Installation Manual
8
5 Photocell
6 Fixed key command (push
button or key)
7 Antenna
Nº threads x section
2
3x1.5mm
2
2x0.5mm
2
2x0.5mm
2
2x0.5mm
2
Duct (2x1mm + interior screened
2
duct 2x0.5mm )
2
2x0.5mm
k
Coaxial cable 50 (RG-58/U)

The installation is activated by way of the fixed key
commands (6) (push button, key switch, proximity
key or magnetic key), or by way of radio transmitter.
With IZAR operator
G
8 Lower closing stopper
(required to programme the
run in operators with
encoder)
Maximum length
30m
20m
30m
25m
8m (maximum 25m with cable
2
2x2.5mm )
25m
5m