Installation; Tools And Materials Required; Initial Conditions And Checks; Content - Erreka AM600S Manuel De L'installateur

INSTALLATION

1

TOOLS AND MATERIALS REQUIRED

• Set of screwdrivers
• Electrician's scissors
• Marker pencil
2

INITIAL CONDITIONS AND CHECKS

Initial installation conditions

Ensure the operator is correctly installed in the
gate.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the direct current connection and
installation fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
3

CONTENT

22
Installation Guide
• Drill and broaches
• Tape measure
• Electrical cables

It is necessary to have a current of 230Vac/
50Hz; 125Vac/ 60Hz, with earth connection.

Check that the admissible environmental
temperature range for the control board is
suitable for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
• The direct connection point must be high
enough to be out of the reach of children.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
1 Open the package and remove the contents from
within.
}
Discard the packaging in an environmentally
friendly manner, using recycling containers.

Do not leave the packaging within the
reach of children or handicapped people, as it
may cause injury.
2 Check the content: control board with case,
attachment screws and installation guide.

Should it be noticed that a piece is missing or
deteriorated, contact the nearest technical service.