JVC KD-AVX40 Manuel D'instructions page 58

Menu items
Delete Pairing
New Pairing
Auto Connect
Auto Answer
SMS Notify
Add Phonebook
MIC Setting
Phone Volume
Initialize
Information
1
* Depends on the amplifier gain control. (☞ page 56)
* 2
If you wish to receive more information about Bluetooth, visit the following JVC web site:
<http://www.jvc.co.jp/english/car/> (English website only)
When operating the Bluetooth device, refer also to the instructions supplied with the device.
Selectable settings, [reference page]
Only for the registered devices.
Delete the registered devices, ☞ [32]
Enter the PIN code to establish the connection, ☞ [31]
Once the connection is established, it is registered in the unit. You
can connect the unit and the device by using <Phone Connect>/
<Audio Connect> from the next time on, ☞ [57]
When the unit is turned on, the connection is established automatically
with...
Off: No Bluetooth device.
Last: The last connected Bluetooth device.
Off: The unit does not answer the calls automatically. Answer the calls
manually.
On: The unit answers the incoming calls automatically.
Reject: The unit refuses all incoming calls.
Off: The unit does not inform you of the arrival of a message.
On: The unit informs you of the arrival of a message by ringing and
displaying "Receiving Message."
Copy the phone book memory of a cellular phone into the unit. You can
register up to 100 phone numbers, ☞ [34]
Adjust the volume of the microphone connected to the unit.
01, 02, 03
Adjust the phone volume.
1
00 to 30 or 50* , Initial 15
Initialize all settings you have made in <Bluetooth>.
Yes: Initializes the settings.
No: Cancels.
The following information is shown:
Name: The unit name
Address: The Mac address of the unit
Version: The Bluetooth software/hardware versions*
Phone Device/Audio Device: The connected device names
58
2