Manner Of Operation; Cutting Grass; Vertical Cut / Lawn Edge Trimming; Cleaning And Maintenance - Grizzly ART 2420 Lion Traduction De La Notice D'utilisation Originale

GB
Adjusting the line length manually:
• Switch off the device and remove
the battery (
Press the retaining head (
lease it again and pull the ends of the
cord out.

Manner of operation

WARNING. Danger of injury!
• Do not cut moist or wet grass.
• Before starting the trimmer check
that the cutting head will not
come into contact with stones,
rubble or other foreign bodies.
• Switch on the trimmer before you
approach the grass that is to be cut.
• Do not overload the trimmer dur-
ing operation.
• Avoid contact with obstacles
(stones, walls, fences, etc.) since
this would make the string wear
out too quickly. Use the edge of the
protective cover to keep the appli-
ance away from such obstacles.

Cutting grass

series of levels from top to bottom.
Vertical cut / lawn edge
trimming
Be particularly careful and atten-
tive when holding the cutter head
vertically. To avoid injuries, keep
34
18) from the device.
I
17) re-
Cut the grass by
swaying the trimmer
sideways to the right
and left. Cut slowly
while the trimmer is
tilted forwards by
approx. 30°.
Cut tall grass by a
enough distance to the trimming
assembly.
Setup for vertical trimming:
G
Move the appliance to the right
and left in a slow swinging motion
to trim slopes and steep inclines.
• Handle rod: 180° (see
• Cutting angle: 0° (see
• Spacer bow in parking position
Setup for edge trimming:
To trim lawn edges, slowly move
the appliance along the lawn edges.
• Handle rod: 90° (see
• Cutting angle: 90° (see
• Spacer bow in parking position

Cleaning and maintenance

Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
„
F
)
ƒ
)
F
„
F
)
ƒ
F )