Trimmer Settings; Lengthening The Cutting Lines - Grizzly ART 2420 Lion Traduction De La Notice D'utilisation Originale

slow down the moving cutting
insert. Risk of injury!

Trimmer settings

F
To adjust the auxiliary handle:
The auxiliary handle can be set to various
positions. Set the handle in such a manner
that the cutting head (
ting forwards when in the working position.
Loosen the screw (6) in the handle

and move the auxiliary handle (5) to your
favourite position. Tighten the screw in the
handle.
To adjust the height:
The telescopic shaft allows you to adjust
the appliance to your personal size.
Loosen the threaded bush
‚
(9). Adjust the telescopic shaft (10)
to the correct length and tighten the
threaded bush.
To adjust the cutting angle:
Changing the cutting angle lets you trim
grass at places that a difficult to reach,
e.g. under benches or wall offsets.
Tread on the pedal (16) on the motor
ƒ
housing and tilt the telescopic shaft
(10). There are 5 preset tilt angles
(see "Work instructions").
To adjust the handle rod:
The handle rod can be turned by 90° and
180° (see "Work instructions").
Push down the lock (8) and turn the
„
0° 90° 180°
handle rod
snaps into your favourite position.
13) is slightly til-
(7) until it
To adjust the spacer bow (flower guard):
The spacer bow keeps the trimming as-
sembly away from plants and trunks not
to be cut.
Push the spacer bow (12) forward.
…
When the spacer bow is
not in use you can move it back to its
parking position.

Lengthening the cutting lines

A short or worn string will make
bad cuts. If you notice reduced cut-
ting performance, you should the-
refore check if there is still enough
string on the spool. Pull the power
plug first! Spool replacement is
detailed in section „Replacing the
Trimming Assembly".
Automatic single-string mechanism
Your device is equipped with an automatic
single-string mechanism. The string ex-
tends automatically during every starting
process. For the correct functioning of the
automatic string extension mechanism,
the spool must have stopped before you
restart the device. If the string is initially
longer than the cutting diameter, it is auto-
matically shortened to the right length by
string cutter.
Regularly check the nylon lines for
damage and whether the lines still
have the correct length defined by
the line cutter
When no line ends are visible:
• Renew the line spool (see "Cleaning
and maintenance").
GB
33