Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
012894
Short nail adapter
1
012947
2
012948
Attach the short nail adapter to prevent the short nails
from being jammed when you use nails shorter than 25
mm (1 ").
Insert the short nail adapter into the slit in the rear of the
magazine. Then fix the adapter by tightening the bolt.
OPERATION
WARNING:
Do not touch around the exhaust vent. The
•
surface will be very hot during or after an operation.
Touching around the exhaust vent may cause
burns or injuries.
CAUTION:
Make sure all safety systems are in working order
•
before operation.
1. Nose adapter
1
1. Short nail
adapter
1. Short nail
adapter
2. Bolt
1
012817
1.
To drive a nail, place the contact element against
the workpiece.
The fan motor is activated, fuel gas is injected into
combustion chamber and mixed with air by the fan.
1
012818
2.
Hold the contact element pressing firmly and pull
the trigger.
Fuel gas is combusted and the nail is driven.
3.
Further driving can be initiated only after both the
contact element and the trigger are released.
Anti dry fire mechanism
This mechanism prevents the tool from firing without nail.
Dry fire prevention automatically functions when the rest
of nails get to the last 9-11 pieces.
Jammed nailer
WARNING:
Always be sure to remove the fuel cell and the
•
battery cartridge before clearing a jam.
CAUTION:
Do not use deformed nails or nail strip. Failure to do
•
so causes poor nail feeding.
Follow the removing nail procedure and remove the nails
in the magazine.
1
2
012819
9
1. Trigger
1. Latch
2. Door
Publicité
Table des Matières
