Symbols On The Product; Product Information - Hilti DD AF-CA H Mode D'emploi

1.3 Product-dependent symbols
1.3.1

Symbols on the product

The following symbols can be used on the product:
Alternating current
Protection class II (double insulated)
The product supports wireless data transfer.
If applied on the product, the product has been certified by this certification body for the US and
Canadian markets according to the applicable standards.
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Auto-feed unit
Generation:
Serial no.:
2 Safety
2.1 Safe operation of the auto-feed unit
WARNING
Non-compliance with safety instructions of the system products! The auto-feed unit is a system product
that is used only in combination with a diamond core drilling machine and a drill stand.
▶ Use the auto-feed unit only with compatible system products listed in the section headed "Intended use".
▶ Also study and follow all instructions relating to safety and operation in the corresponding operating
instructions of the system products (diamond core drilling machine, drill stand).
Study all safety instructions and other instructions, images and technical data with which this power
tool is provided. Failure to observe the instructions below or the instructions of the system products can
result in electric shock, fire and/or serious injury.
Keep all safety precautions and instructions for future reference.
The term "power tool" used in the safety precautions refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
General safety instructions
▶ When you operate the drilling system with auto-feed unit, always secure the drill stand by means
of anchors. The use of a vacuum pump is not permissible. When the auto-feed unit is operating in
automatic mode, the vacuum base plate can become detached if the vacuum unexpectedly drops below
the specified range.
▶ Keep the power tool out of reach of children.
▶ Remove the hand wheel when you are going to operate the drilling system with the auto-feed unit.
When the auto-feed unit is operating in automatic mode, the hand wheel tends to turn and can lead to
injuries or cause cables or hoses to become wrapped around it.
▶ Make sure that the power tool is correctly and securely mounted on the drill stand. The auto-feed
unit has to be engaged at one of the keyed positions and it must be secured with the securing screw.
Additional safety instructions
▶ Make sure that the supply cord cannot be damaged as the carriage advances.
2 English
DD AF-CA H
01
2299965
*2299965*