Installation; Installing The Monitor; Pairing The Camera And The Monitor - Abus TVAC16000C Notice D'utilisation

6. Installation

6.1 Installing the monitor

1. Connect the power supply unit to the monitor.
2. Switch the device on. Press the power button for about 5 seconds.
Important:
Please note that if the monitor does NOT have an external power supply, it must be
charged for at least 8 hours prior to being used for the first time.
The batteries will provide power for approx. 1.5 hours.
Important:
The integrated battery allows you to use the LCD monitor flexibly.
If the battery symbol
that the battery must always be charged sufficiently so as to ensure loss-free recording.

6.2 Pairing the camera and the monitor

To connect a camera with the monitor, proceed as follows:
1. Connect the camera and the monitor to the power supply.
In the monitor menu, select "Camera", then "Pairing" and the required camera (1-4). The system counts
2.
down from 60 seconds.
3. During the 60 seconds, press the PAIRING button on the camera cable until the green LINK LED on the
front of the camera starts flashing.
4. The LINK LED is lit up continuously once the connection is established.
Important:
Please note that the connection can take up to 60 seconds.
lights up in red, then the batteries must be charged. Please note
13
English