Loading Battery - Carson X-18 Mode D'emploi

Trouble shooting ESC Brushless
Trouble
After power on, motor doesn't work
After power on, motor doesn't work, but
emits "beep-beep-, beep-beep-" alert tones
(Every group of "beep-beep-" has a time
GB
interval of 1 second)
After power on, red LED always lights, the
motor doesn't work
The motor runs in the opposite direction
when it is accelerated
The motor suddenly stops running
When accelerating quickly, the motor stops
or trembles
g. Loading Battery
Attention:
Only use the specially provided charger units to charge the nickel
metal hydride batteries!!!
Otherwise your drive battery could be damaged.
The charging time will vary according to the charger unit and battery
type.
28 CARSON X-18 50 040 40 25 + 50 040 40 26
Possible reason
The connections between battery pack and
ESC are not correct
Input voltage is abnormal, too high or too
low
Throttle signal is abnormal
The wire connections between ESC and the
motor are not correct
The throttle signal is lost
The ESC has entered the "Low voltage
protection mode" or "Over-heat protection
mode"
1. The battery has a bad discharge
performance
2. The "Start mode (Punch)" of the
ESC is too aggressive
Solution
Check the power connections
Replace the connectors
Check the adjustment of the voltage of the
battery pack
Plug the receiver wire into the throttle
channel of the receiver correctly
Swap any two wire connections between the
ESC and the motor
Check the transmitter and the receiver
Red LED flashing means "Low voltage
protection". Please replace battery pack.
Green LED flashing means "Over-heat
protection", please stop running to cool the
ESC.
Use a better battery
Select a softer option for the "Start mode
(Punch)"