Table des Matières
Publicité
INPUT KEY FUNCTION
S/N
Identification
1
Left control lever
2
Rotate trim /
Calibration button
3
On/off switch
4
Right control lever
6
USB charging connector
7
Frequency selection A/B
BATTERY MOUNTING
Attention
• Never mix used and new batteries.
• Never use batteries of different types together.
1
Remove screw of the battery-cover. Remove the cover.
3
Close the battery-case.
GB // 16
Function
Moving the control lever forwards or backwards makes the copter climb or dive.
The rotate trim adjusts the rotation to the left or right. / By pressing both buttons simultane-
ously (power button will flash 3 times) the model will be recalibrated (set to neutral position)
Pressing the switch alters the copter's agility
Moving the control lever forwards or backwards makes the copter move forwards or back-
wards. Moving the control lever to the left or right makes the copter rotate to the left or right.
Charging the helicopter via the transmitter
Press down button for 2 sec. - power button will flash once (frequency "A"), or twice (fre-
quency "B")
• Do not attempt to charge non-rechargeable batteries.
Put fresh AA Mignon batteries with correct polarity into the
battery-case.
Mount the screw of the cover again.
4 x AA (LR06)
2
4
Publicité
Table des Matières
