Publicité
Les langues disponibles
Les langues disponibles
Any liquid coming from dislayed food sould be immediately cleaned with a wet cloth. Please pay special attention to
glasses.
Clean the unit on a regular basis with neutral soap and then dry with a soft cloth. Never use flammable or abrasive
products. Never clean the unit with direct jets of water. When cleaning the inside of the unit, always wear protective
gloves.
Avoid that top lightings, electrical wiring and all electrical equipment are wet during cleaning operations.
Warning: Only plug the unit back in after checking that all parts (extracted or otherwise) are dry. Reload the unit following
the instructions in point 7.
10 – Unit maintenance
Warning: All maintenance operations should be carried out by expert personnel.
Warning: Unplug at the mains before servicing.
Warning: Other maintenance operations, (not described herein) including replacement of lamps with lamps of the same
model, have to be commissioned to authorised centres of assistance or qualified personnel.
11 – Emergencies
Warning: If the unit stops or doesn't start:
-
Check there isn't a black-out.
-
Check the unit is plugged in properly.
-
Check the switch fitted above the plug (if any) is flipped.
If the problem persists despite the above checks, contact your nearest service centre and empty the unit (placing the
products in suitable storage cells to avoid breaking the cold chain).
Warning: If the unit doesn't keep the products warm enough:
-
Check that the unit has been loaded properly; otherwise, see point 7.
-
Check that the unit is not close to strong air flows (see point 4).
-
Check that the unit is levelled and that the environmental conditions meet those indicated in point 4.
If the problem persists despite the above checks, contact your nearest service centre.
Warning: Never approach the cabinet in the event fire. Unplug at the mains. Never use water to put out any flames, but
only CO
extinguishers.
2
12 - Customer service
If you need the assistance of a technician or mechanical, electrical components need to be replaced, please contact the
dealer from whom you bought the unit and ask for original spare parts.
13 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries.
14 - Manufacturer's statement (Start-up prohibition)
The above models are also built to be assembled in-line with other items of machinery to produce a machine, as defined
by Directive 2006/42/CE.
Therefore, the Manufacturer hereby states that it not permitted to start the unit up until the machine in which it is
incorporated or will become a part of has been identified and its compliance with the provisions of Directive 2006/42/CE
and applicable national laws has been stated. In other words, until the machine referred to in this statement becomes one
with the final machine.
15 - Wiring diagrams
The wiring diagram can be seen on FIG. 7.
Legend:
Ce = Electronic control
IL = Heaters switch
St = Thermostat probe
TR = Transformer
Kx = Relay x
Rx = Heater x
16 - Conformity Declaration
A copy of the declaration of product conformity can be requested by filling in the form available a the internet address:
http://www.oscartielle.it/conformity
13
Publicité
