EIBENSTOCK EMF 180.1 Notice Originale page 22

Fig.3
Fig.4
Pre-selection of the Groove Width :
•
The groove width results from the number and thickness of the spacer discs
between the two diamond cutting discs and the cutting width of the diamond
cutting discs.
The grove width is calculated as follows: groove width = Thickness of the
spacer discs + width of the diamond cutting discs.
Thickness of the spacer discs: 2x 3, 2x 6, 2x 10 and 1x 19.5 mm
Fig 5
Press the spindle lock button to lock the
work spindle .
Actuate the spindle lock button only
when the work spindle is at a standstill.
Otherwise, the machine may become
damaged.
Open the clamping screw with the face
spanner and remove the diamond cutting
discs as well as the spacer discs from
the work spindle
Clean the work spindle and all parts
to be mounted.
First the wheel flange has to be mounted on the
work spindle (see arrow).
The wheel flange with its driving must have a
correct seat on the work spindle.
Then mount one of the two diamond cutting discs.
After that put the spacer discs and the second
diamond cutting disc according to the required
groove width on the work spindle.
22
.