Hitachi DH 24PC2 Mode D'emploi Et Instructions De Securite page 15

6. Hammering only
This rotary hammer can be set to
hammering only mode by pressing the
push button and turning the change
lever to mark. (Fig. 12)
(1) Mount the bull point or cold chisel.
(2) Press the push button and set the
change lever to middle of
mark. (Fig. 13)
The rotation is released, turn the grip
and adjust the cold chisel to desired
position. (Fig. 14)
(3) Turn the change lever to
(Fig. 12)
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 15)
(1) Loosen the knob on the side handle,
and insert the depth gauge into the
mounting hole on the side handle.
(2) Adjust the depth gauge position ac-
cording to the depth of the hole and
tighten the knob bolt securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 16)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 16)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
Mounting Hole
Knob on Side
Handle
Fig. 15
mark and
mark.
Depth Gauge
Change Lever
Push
Button
Fig. 12
Change Lever
Push
Button
Fig. 13
Grip
Fig. 14
Drill Bit
Taper shank
Front Cap
Adaptor
Fig. 16
English
Grip
15