Symbol Meanings - Hettich ROTANTA 460 Mode D'emploi

Masquer les pouces Voir aussi pour ROTANTA 460:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For further details of available biosafety systems see chapter "Anhang/Appendix, Rotoren und Zubehör/Rotors
and accessories". If in doubt, you should obtain relevant information from the manufacturer.
The centrifuge must not be operated with highly corrosive substances which could impair the mechanical integrity
of rotors, hangers and accessories.
Repairs must only be carried out by personnel authorised to do so by the manufacturer.
Only original spare parts and original accessories licensed by the Andreas Hettich GmbH & Co. KG company are
allowed to be utilised.
The following safety regulations apply:
EN / IEC 61010-1 and EN / IEC 61010-2-020 as well as their national deviations.
The safe operation and reliability of the centrifuge can only be guaranteed if:
− the centrifuge is operated in accordance with the operating instructions,
− the electrical installation on the site where the centrifuge is installed conforms to the demands of EN / IEC
stipulations,
− prescribed tests to BGV A1, BGR 500 are carried out by an expert.
5

Symbol meanings

Symbol on the machine:
Attention, general hazard area.
Before using the centrifuge implicitly read the operating instructions and pay attention to the safety
relevant references!
Symbol in this document:
Attention, general hazard area.
This symbol refers to safety relevant warnings and indicates possibly dangerous situations.
The non-adherence to these warnings can lead to material damage and injury to personal.
Symbol on the machine and in this document:
Beware of hot surface.
Nonobservance of this warning can lead to material damage and personal injury.
Symbol on the machine and in this document:
Beware of biohazard.
Symbol on the machine:
Equipotential: Connector (PE connector) for potential equalization (only for centrifuge with PE
connector).
Symbol on the machine:
IOIOI
RS232
RS232 interface (only for centrifuges with RS232 interface).
Symbol on the machine:
F2
Automatic circuit breaker (only for types 5650-01, 5660-01 and 5660-51.
Symbol in this document:
This symbol refers to important circumstances.
Symbol on the machine and in this document:
Symbol for the separate collection of electric and electronic devices according to the guideline
2002/96/EG (WEEE). The device belongs to Group 8 (medical devices).
Applies in the countries of the European Union, as well as in Norway and Switzerland.
EN
37/147

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rotanta 460 rRotanta 460 rcRotanta 460 rf

Table des Matières