Installing The Handle; Operating Conditions - AVG VPC46DS2 Manuel D'utilisation

2. INSTALLATION INSTRUCTIONS (

INSTALLING THE HANDLE

To install the handle, please follow these instructions:
1. Pull away the door gasket from the area where the handle is to be installed, on the left side, as shown
in Fig. 1. The gasket may be easily removed by hand, no tools are required.
2. Align the handle with the screws to be installed. Tighten the screws using a Phillips head screwdriver
until the handle sets both flush and secured tightly against the door frame. DO NOT over-tighten as
this will cause damage to the handle assembly. Refer to Fig. 2. Replace the door gasket in its
original position.

OPERATING CONDITIONS

Proper operation of the appliance is guaranteed only if the following conditions are met:
• The temperature in the room where the appliance is located conforms to the climate class stated
on the appliance's rating label.

Maximum ambient relative humidity: RH75%.

The appliance must be placed at a sufficient distance from heat sources (i.e., ovens, central
heating, direct sunlight, etc.).

The appliance must be located in such a place that it is protected against the effects of weather.

Regular maintenance is performed according to the instructions in this user's manual.

The ventilation openings on the appliance must not be covered.

Correct installation (e.g. leveling, the capacity of the system corresponds to the specifications
on the rating label of the appliance).
)
CONTINUED
22