Installing The Handle; Operating Your Appliance; Controls - AVG VINOPAZZO VPC27SS Manuel D'utilisation

2. INSTALLATION INSTRUCTIONS (continued)

INSTALLING THE HANDLE

To install the handle, please follow the following instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Fig .1. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws installed. Tighten the screws using a Phillips head
screwdriver until the handle sets both flush and secured tightly against the door frame. DO
NOT over tighten as this will cause damage to the handle assembly. See Fig .2. Replace the
door gasket to its original position.
Fig. #1
 Gasket

Phillips Head Screw

3. OPERATING YOUR APPLIANCE

CONTROLS


"
": ON and OFF button: press and hold for approximately three (3) seconds to turn
the unit on or off.

" ": 'Energy Conservation' button: press and hold for three (3) seconds to turn the
energy conservation mode ON or OFF. In this mode, the LED light and display will turn
off and the °C/°F light will be on.

" ": Indicator light: shows that the compressor is in operation.

" " Increase button: press to increase temperature in increments of 1 degree (F or C).

" " Decrease button: press to decrease temperature in increments of 1 degree (F or C).

"°C/°F" Degree button: press to switch the temperature degrees between °C/°F.

" " Light button: turns the interior light ON and OFF. If you use this button, the light
is no longer controlled by the switch and remains ON (the Light button is deactivated
when 'Energy conservation' button is on). LED display screen shows the temperature
setting.
 Phillips Head Screw Driver
 Handle
20
Fig. #2