Reversing The Door - AVG VINOPAZZO VPC27SS Manuel D'utilisation

2. INSTALLATION INSTRUCTIONS (continued)

REVERSING THE DOOR

IMPORTANT: THIS OPERATION REQUIRES AT LEAST TWO (2) PERSONS.
INSTRUCTIONS
1. Open the door at a 90 degree angle, take out 2 screws from lower door axis (#3) and pull out
door.
2. Set the door aside in a safe place and take out decorative nail (#7) from top of door frame.
Remove the 2 screws (#4) at bottom and take out the Extrusion-board of lamp switch (#5).
Install the Extrusion-board of lamp switch (#5) at top of door frame and use spare decorative
nails to block the hole at top of door frame.
3. Unscrew the 3 screws (#8) from top right hinge (#6) and take out the right top hinge.
4. Remove the decorative nails (#10) from left top of cabinet and install the spare top hinge (#9) at
left top of cabinet using the 3 screws.
5. Install spare lower hinge (#11) onto left lower cabinet.
6. Rotate the door 180 degrees, then re-install it in the same way it was removed, making sure it is
aligned properly.
7. Block the hole at right top of cabinet with the spare decorative nail.
11
19